Req for details on Procede's PWM Meth injection

[uniter]

Hey all,
Looking for someone to provide at best some details around pin-out for the procede to integrate w/ pump or at least some high quality pics of both ends of the connectors / relay & related wiring.

There's also a hobbs switch, does anyone know what PSI it activates at? Or have a P/N for it?

Thanks!

[xbox_fan]

I assume you emailed Vishnu support, what did they answer

[Tzu]

Going off memory here, but the pump is permanenet grounded and the positive is relayed from a hot distribution block near the CP. The hobbs switch activates at 5psi (set by vishnu) and is adjustable. The hobbs switch switches the relay for the hot wire for the pump at 5psi. This next part is fuzzy, but I think the FAV and flow meter grounds near the CP, and hot wires goes to the pinouts of the procede. I don't have the pin numbers on me...check http://procedetuning.com/BMW/n54/met...all/index.html for the pinouts.

[uniter]

Hmmm

Yeah you can kinda make everything out from looking at pictures...

[mycoupe]

Wtf is up with everyone asking questions that they should be emailing/calling the company for lately?

[SCGT]

I agree. Very odd. Unrelatedly, anyone have the pulley to spider shaft tightening torque for a maytag MAH5500BWW?

[mycoupe]

I agree. Very odd. Unrelatedly, anyone have the pulley to spider shaft tightening torque for a maytag MAH5500BWW?

600in•lbs. Try that and see if it works. I take no responsibility for sheared bolts. Haha



edit: although, if you give me the bolt size and thread count and material, I can give you it's max torque. Knowing that, you could appropriately torque down the bolt...assuming they actually calculated the size bolts they need for everything to provide enough torque and not waste money over doing it.

[SCGT]

Repped. I was joking about the bolt, of course, but I do appreciate your willingness to help, which is what this forum is about.

[mycoupe]

Repped. I was joking about the bolt, of course, but I do appreciate your willingness to help, which is what this forum is about.

yeah, at first I was just going to post to twist it till you hear a pop, then back it off a quarter turn. Hahaha

[uniter]

This isn't a question that Vishnu would answer.... (I did email them) @mycoupe @SCGT
They were willing to sell me a harness, though.

FWIW most companies don't really support you when you're reverse engineering a product that they sell.

[Tzu]

This isn't a question that Vishnu would answer.... (I did email them) @mycoupe @SCGTThey were willing to sell me a harness, though.FWIW most companies don't really support you when you're reverse engineering a product that they sell.

Or when you own their componenets already, it would seem.

[Sticky]

Wtf is up with everyone asking questions that they should be emailing/calling the company for lately?

Because you get better support here for Vishnu products than you do from Vishnu themselves.

[mycoupe]

Because you get better support here for Vishnu products than you do from Vishnu themselves.

eh, I guess it just depends on how you ask? I've never had problems getting support or Shiv's personal cell. Always gotten a text back, or my call answered.

[Sticky]

eh, I guess it just depends on how you ask? I've never had problems getting support or Shiv's personal cell. Always gotten a text back, or my call answered.

Must be your good looks.

[mycoupe]

Must be your good looks.

or lack there of! Haha...I am into cars and most of us aren't too pretty if you know what I mean! Haha