New to the BMW world, fuel it stage 3 help

[09STBMW]

Hey guys I appreciate the add! I just wanted to introduce myself, I live just west of st louis MO. Huge fan of DSM's, Subaru's, a couple built motors. I've been in the saab game for about 7 years and never truely knew power til now. I wanted to try what everyone has been talking about. The N54 platform... I purchased Drepai's 09 335i ST car. Car is amazing. I've fallen in love again.
List goes as follows, VM/ACF 6466, PI with controller, fuel it stage 3 kit, spec 3 + Mfactory flywheel,
Vrsf IC, phenoix charge pipe,Jb4 and mhd BEF low boost e85 map 2.
Especially being single turbo and a california car(no rust)! The car has a history to it, no car accidents but a blown motor... The old owner had a 40k n54 swapped professionally in the car. Everything has been checked out and confirmed. Car is insane. I'm surprised I found this rare gem and the condition its in for being a 9 year old car!

Fast forward to today Ive had the car for 2 weeks now, the car has a couple I wouldnt say issues but things I'd deff like to fix.
It has the stage 3 fuel it kit. With a hobbs switch. Previous owner states the secondary fuel pump is not kicking on with 15psi hits.
Where do I start to look for issues?
Ive attached a picture of the wiring to the battery and I think the 12+ switch (white wire) is likely the culprit but maybe something else? I dont think the power wire (red) and 12+ switch (white) should be together?
All the other wiring looks correct. Where do you guys install your 12+ switched wire?

Attached is the pic of the relay latout.


Should I do a few pulls and log it? What parameters do I need to log to see if the second fuel pump it kicking on?

[Sticky]

@Dave@Fuel-It!

[Payam@BMS]

Red- Battery Positive
Blue- Positive from secondary pump
Black- Battery Negative
White- Going to the front of the car connecting to an Orange/Yellow wire hanging off the JB4 PI controller.

[09STBMW]

The fuel pump ground goes to the battery.
The black wire is the trigger wire feom the hobbs switch.
Okay so ill connect the white to the PI controller.

[Payam@BMS]

The fuel pump ground goes to the battery.
The black wire is the trigger wire feom the hobbs switch.
Okay so ill connect the white to the PI controller.

You should not be using a hobb switch, take a picture of your PI controller. The trigger is off the PI controller wire you just need to follow the directions I posted above.