NEW Fuel-It! Stage 2 Bucketless LPFP for the E-Series

[Dave@Fuel-It!]

Hey All,

We've been doing quite a bit of R&D lately, working on a lot of products and finally got everything in for our new Stage 2 bucketless LPFP. In this thread we'll be publishing videos, install procedures, and options.

To start with, here is a brief video overview of the pump assembly and a side by side comparison with our standard Stage 2 pump.



Most are going to ask why we developed this and what the pros and cons are over our current Stage 2.

There were two reasons for this development:

First, and foremost we wanted to provide more flow and better pressures. As you can see in the video we increased flows by approximately 27%. Second, we wanted to eliminate the need to modify the stock bucket and the hassle of core deposits or DIY projects.

Stage 2 bucketless accomplishes all of those by enabling you to order a true plug and play assembly with no modifications or core exchange and achieve greater flows. This allows you to return to stock at any time should you decide to sell the car or take it to the dealer for service.

Our Stage 2 bucketless assembly will include a standard filter. With this filter in our testing you can run the fuel down to 1/16 of a tank and still be able to do full throttle pulls without fuel starvation issues. We were then able to run the tank down to zero miles showing but hard accelerations would lead to fuel starvation. Normal accelerations and casual driving was not an issue. The cost for this option will be $399.95 and we will begin taking orders on Monday Dec. 19th.

Here is a video testing with the standard filter and the tank showing empty. We did 3 accelerations like this with the tank showing empty before we ran in to fuel starvation issues.



In addition to this option we will have 2 other custom filter options that will be available in the next few weeks.

Option 1
This filter is for those that run their tank in low fuel conditions while still doing hard pulls and full throttle accelerations. Price to be determined once the production run has been completed.

Option 2
This filter will be for those canyon carvers or road course guys (and gals) that do a lot of cornering under low fuel conditions. If you're a track person this will be the filter we'll recommend for you. Price to be determined after the production run is completed. We will have the first batch of these filters in next week.

As always, thank you for your continued support!

[Dave@Fuel-It!]

Hey all,

Sorry for the delay, we were finally able to get you guys some dyno #'s for our stage 2 bucketless setup.

This was done on our 135i that is running our Platinum Port Injection kit on
Arizona's "E85" (E52). It's running the latest BMS E85 flash that targets
11.9:1.

600whp was no problem, not bad for a single pump that is plug and
play, under $400 and you still get to keep your original LPFP for returning to
stock or dealer visits

Thanks for your past & as always support!

[Weehe]

Looks good. I plan to get one in the next month. Never run below 1/4 tank, so really am not concerned.