Can't get smooth boost target with Boost Limit Multiplier per Gear

[bradsm87]

I'm having trouble getting a smooth 1st gear boost target with boost limit multiplier per gear.

I run 160 load target in 1st and the following boost limit multiplier per gear values. It is a very smooth increase slope:



Here is a log:

http://datazap.me/u/bradsm87/rr600-r...8&zoom=225-245

As you can see, there is a huge sudden step in boost target somewhere between 2700 and 3000rpm, then the boost target slowly drops off again.

The problem with the big and sudden step is that WGDC drops right down when the actual boost approaches the very low target before the step, making it laggier than it needs to be.

Load per gear was a lot easier to set up. It's a shame about the big power surge between 1st and 2nd when LPG is used with AT.

How are people getting a smooth boost target with boost limit multiplier per gear? Can anyone share their values that work well?